polyoxymethylene kluzně modifikován (POM AX)

We use this material in the following process(es):

Extruded profiles and semifinished products

Machined parts.
Lathed and milled parts in single and serial production

Injection moulding.
Injection moulded parts up to 16.000 g

Material number   1214  
Density ISO 1183 1,33 g/cm3

Mechanical properties

Stress at yield ISO 527 40 MPa
Elongation at break ISO 527 17 %
Tensile modulus ISO 527 2100 MPa
Ball pressure hardness ISO 2039-1 105 MPa
Standard for ball pressure hardness   H961/30  

Electrical properties

Volume resistivity IEC 60093 1,00E+14 Ohm · m
Surface resistivity IEC 60093 1,00E+14 Ohm

Thermal properties

Linear thermal expansion along|cross to direction of flow ISO 11359 140 10-6/K
Melting point or glass transition temp. ISO 11357 165 °C
Heat distortion temperature A ISO 75 HDT/A (1.8 MPa) 80 °C
Short time use temperature   140 °C
Continuous use temperature   80 °C
Minimal use temperature   -50 °C

Other properties

Humidity absorption at 23°C/50% ISO 62 0,16 %
Water absorption ISO 62 0,7 %
Transparency (opaque/translucent/clear)   opaque  

This datasheet is a print-out of the material database RIWETA 4.0 and is intended for personal use only.

The figures in this datasheet are guide values. The values are affected by processing conditions, modifications, additives and environmental conditions and they do not release you from the obligation to check the validity and to undertake tests on your own. The information given is based on our state of knowledge. The material data is not to be construed as guaranteeing specific properties and the data can not be used to deduce the suitability for a particular application.

It remains the responsibility of the user of our products not to infringe patent rights and to comply with existing laws and regulations.

LPM s.r.o.
Technické díly z plastů
Koněvova 536
CZ-506 11 Jičín

© 2008 by LPM s.r.o., Technické díly z plastů
Koněvova 536, CZ-506 11 Jičín, Česka republika, info@lpm.cz