Polykarbonát s 30 % skleněných vláken (PC GF30)

We use this material in the following process(es):

Injection moulding.
Injection moulded parts up to 16.000 g

Thermoplastic structure foaming (TSF).
Multi functional parts and housings up to 16 kg

Material number   2313  
Density ISO 1183 1,42 g/cm3

Mechanical properties

Tensile strength ISO 527 55 MPa
Elongation at break ISO 527 4 %
Tensile modulus ISO 527 5000 MPa
Ball pressure hardness ISO 2039-1 145 MPa
Standard for ball pressure hardness   H358/30  
Hardness Shore (A/D) or Rockwell (R/L/M) ISO 868, ISO 2039-2 L107 -
Izod notched impact strength at 23 °C ISO 180/1A 6 KJ/m2

Electrical properties

Dielectric constant at 50 Hz IEC 60250 3,6 -
Dielectric constant at 1 MHz IEC 60250 3,5 -
Dissipation factor at 50 Hz IEC 60250 10 1E-4
Dissipation factor at 1 MHz IEC 60250 80 1E-4
Dielectric strength IEC 60243-1 36 kV/mm
Thickness for electric strength   1 mm
Volume resistivity IEC 60093 >1013 Ohm · m
Surface resistivity IEC 60093 1,00E+15 Ohm
Comparative tracking index IEC 60112 175 -

Thermal properties

Thermal conductance DIN 52 612 0,22 W/K m
Linear thermal expansion along|cross to direction of flow ISO 11359 40|60 10-6/K
Melting point or glass transition temp. ISO 11357 148 °C
Heat distortion temperature A ISO 75 HDT/A (1.8 MPa) 135 °C
Heat distortion temperature B ISO 75 HDT/B (0,45 MPa) 142 °C
Short time use temperature   140 °C
Continuous use temperature   125 5) °C
Minimal use temperature   -100 °C

Other properties

Humidity absorption at 23°C/50% ISO 62 0,08 %
Water absorption ISO 62 0,2 %
Flammability UL 94 IEC 60695-11-10 V-1 -
Thickness for UL 94   1,5 mm
Transparency (opaque/translucent/clear)   opaque  
Raw material   Makrolon 8035 (Bayer)  

5) : Thermal ageing UL 746 (RTI) Mechanical W/O Imp., 40 000 h

This datasheet is a print-out of the material database RIWETA 4.0 and is intended for personal use only.

The figures in this datasheet are guide values. The values are affected by processing conditions, modifications, additives and environmental conditions and they do not release you from the obligation to check the validity and to undertake tests on your own. The information given is based on our state of knowledge. The material data is not to be construed as guaranteeing specific properties and the data can not be used to deduce the suitability for a particular application.

It remains the responsibility of the user of our products not to infringe patent rights and to comply with existing laws and regulations.

LPM s.r.o.
Technické díly z plastů
Koněvova 536
CZ-506 11 Jičín

© 2008 by LPM s.r.o., Technické díly z plastů
Koněvova 536, CZ-506 11 Jičín, Česka republika, info@lpm.cz