Styren/Acrylonitril s 35 % skleněných vláken (SAN GF35)

We use this material in the following process(es):

Injection moulding.
Injection moulded parts up to 16.000 g

Thermoplastic structure foaming (TSF).
Multi functional parts and housings up to 16 kg

Material number   2163  
Density ISO 1183 1,36 g/cm3

Mechanical properties

Tensile strength ISO 527 110 MPa
Elongation at break ISO 527 2 %
Tensile modulus ISO 527 12000 MPa
Ball pressure hardness ISO 2039-1 240 MPa
Standard for ball pressure hardness   H358/30  
Hardness Shore (A/D) or Rockwell (R/L/M) ISO 868, ISO 2039-2 M93 -
Izod notched impact strength at 23 °C ISO 180/1A 4 KJ/m2
Charpy notched impact strength at 23 °C ISO 179/1eA 4 KJ/m2

Electrical properties

Dielectric constant at 50 Hz IEC 60250 3,5 -
Dielectric constant at 1 MHz IEC 60250 3,2 -
Dissipation factor at 50 Hz IEC 60250 70 1E-4
Dissipation factor at 1 MHz IEC 60250 100 1E-4
Thickness for electric strength   1 mm
Volume resistivity IEC 60093 1,00E+14 Ohm · m
Surface resistivity IEC 60093 1,00E+15 Ohm
Comparative tracking index IEC 60112 600 -

Thermal properties

Thermal conductance DIN 52 612 0,19 W/K m
Linear thermal expansion along|cross to direction of flow ISO 11359 25|- 10-6/K
Melting point or glass transition temp. ISO 11357 106 °C
Heat distortion temperature A ISO 75 HDT/A (1.8 MPa) 105 °C
Heat distortion temperature B ISO 75 HDT/B (0,45 MPa) 108 °C
Short time use temperature   110 °C
Continuous use temperature   90 4) °C
Minimal use temperature   na °C

Other properties

Humidity absorption at 23°C/50% ISO 62 <0,1 %
Water absorption ISO 62 0,25 %
Flammability UL 94 IEC 60695-11-10 HB -
Thickness for UL 94   1,7 mm
Transparency (opaque/translucent/clear)   opaque  
Raw material   Luran 378P G7 (BASF)  

4) : Thermal ageing, reduction of tensile strength by 50 % after 20 000 h
na: not applicable

This datasheet is a print-out of the material database RIWETA 4.0 and is intended for personal use only.

The figures in this datasheet are guide values. The values are affected by processing conditions, modifications, additives and environmental conditions and they do not release you from the obligation to check the validity and to undertake tests on your own. The information given is based on our state of knowledge. The material data is not to be construed as guaranteeing specific properties and the data can not be used to deduce the suitability for a particular application.

It remains the responsibility of the user of our products not to infringe patent rights and to comply with existing laws and regulations.

LPM s.r.o.
Technické díly z plastů
Koněvova 536
CZ-506 11 Jičín

© 2008 by LPM s.r.o., Technické díly z plastů
Koněvova 536, CZ-506 11 Jičín, Česka republika,