polyamide 66 s 20 % uhlíkových vláken (PA 66 CF20)



We use this material in the following process(es):

Extrusion.
Extruded profiles and semifinished products

Machined parts.
Lathed and milled parts in single and serial production

Injection moulding.
Injection moulded parts up to 16.000 g

Thermoplastic structure foaming (TSF).
Multi functional parts and housings up to 16 kg


Material number   1156  
Density ISO 1183 1,22 g/cm3
Condition of the test specimen   sucho/vlhkost vzduchu  
   

Mechanical properties

Tensile strength ISO 527 220/150 MPa
Elongation at break ISO 527 03. Jun %
Tensile modulus ISO 527 16000/11000 MPa
Ball pressure hardness ISO 2039-1 240/200 MPa
Standard for ball pressure hardness   H961/30  
Izod notched impact strength at 23 °C ISO 180/1A 13/23 KJ/m2
Charpy notched impact strength at 23 °C ISO 179/1eA 13/16 KJ/m2
   

Electrical properties

Dielectric constant at 50 Hz IEC 60250 na -
Dielectric constant at 1 MHz IEC 60250 na -
Dissipation factor at 50 Hz IEC 60250 na 1E-4
Dissipation factor at 1 MHz IEC 60250 na 1E-4
Dielectric strength IEC 60243-1 na kV/mm
Surface resistivity IEC 60093 30. Mai Ohm
Comparative tracking index IEC 60112 na -
   

Thermal properties

Thermal conductance DIN 52 612 0,43 W/K m
Linear thermal expansion along|cross to direction of flow ISO 11359 25|75 10-6/K
Melting point or glass transition temp. ISO 11357 260 °C
Heat distortion temperature A ISO 75 HDT/A (1.8 MPa) 245 °C
Heat distortion temperature B ISO 75 HDT/B (0,45 MPa) 250 °C
Short time use temperature   240 °C
Continuous use temperature   120 °C
Minimal use temperature   -40 °C
   

Other properties

Humidity absorption at 23°C/50% ISO 62 2 %
Water absorption ISO 62 6,5 %
Transparency (opaque/translucent/clear)   opaque  
   
na: not applicable

This datasheet is a print-out of the material database RIWETA 4.0 and is intended for personal use only.

The figures in this datasheet are guide values. The values are affected by processing conditions, modifications, additives and environmental conditions and they do not release you from the obligation to check the validity and to undertake tests on your own. The information given is based on our state of knowledge. The material data is not to be construed as guaranteeing specific properties and the data can not be used to deduce the suitability for a particular application.

It remains the responsibility of the user of our products not to infringe patent rights and to comply with existing laws and regulations.

LPM s.r.o.
Technické díly z plastů
Koněvova 536
CZ-506 11 Jičín



© 2008 by LPM s.r.o., Technické díly z plastů
Koněvova 536, CZ-506 11 Jičín, Česka republika, info@lpm.cz