polyamide 6 litý s 30 % skleněných kuliček (PA 6 G GB30)



We use this material in the following process(es):

nylon cast.
Semifinished products and moulded parts up to 2 tons

Machined parts.
Lathed and milled parts in single and serial production


Material number   1136  
Density ISO 1183 1,38 g/cm3
Condition of the test specimen   sucho/vlhkost vzduchu  
   

Mechanical properties

Tensile strength ISO 527 80/55 MPa
Elongation at break ISO 527 05. Dez %
Tensile modulus ISO 527 5700/3400 MPa
Ball pressure hardness ISO 2039-1 180/105 MPa
Standard for ball pressure hardness   H358/30  
Hardness Shore (A/D) or Rockwell (R/L/M) ISO 868, ISO 2039-2 D85/D74 -
   

Electrical properties

Volume resistivity IEC 60093 1013/1010 Ohm · m
Surface resistivity IEC 60093 1012/1010 Ohm
   

Thermal properties

Thermal conductance DIN 52 612 0,34 W/K m
Linear thermal expansion along|cross to direction of flow ISO 11359 50 10-6/K
Melting point or glass transition temp. ISO 11357 220 °C
Heat distortion temperature A ISO 75 HDT/A (1.8 MPa) 140 °C
Heat distortion temperature B ISO 75 HDT/B (0,45 MPa) 205 °C
Short time use temperature   200 °C
Continuous use temperature   90 °C
Minimal use temperature   -40 °C
   

Other properties

Humidity absorption at 23°C/50% ISO 62 1,8 %
Water absorption ISO 62 5 %
Flammability UL 94 IEC 60695-11-10 HB -
Transparency (opaque/translucent/clear)   opaque  
   

This datasheet is a print-out of the material database RIWETA 4.0 and is intended for personal use only.

The figures in this datasheet are guide values. The values are affected by processing conditions, modifications, additives and environmental conditions and they do not release you from the obligation to check the validity and to undertake tests on your own. The information given is based on our state of knowledge. The material data is not to be construed as guaranteeing specific properties and the data can not be used to deduce the suitability for a particular application.

It remains the responsibility of the user of our products not to infringe patent rights and to comply with existing laws and regulations.

LPM s.r.o.
Technické díly z plastů
Koněvova 536
CZ-506 11 Jičín



© 2008 by LPM s.r.o., Technické díly z plastů
Koněvova 536, CZ-506 11 Jičín, Česka republika, info@lpm.cz